Design and fabrication of pressure-compensating compliant tubes
Name
897211353-MIT.pdf
Description
Full printable version
Size
3.38 MB
Format
Adobe PDF
Checksum (MD5)
2b1e4d9999e2011c6a331a2612358258
Author(s)
Martin, Ian (Ian P.)
Advisor(s)
Amos G. Winter V.
Date Issued
2014
Publisher
Massachusetts Institute of Technology
Abstract
Different fabrication methods are evaluated for producing pressure-compensating tubes for use in low-pressure drip irrigation systems. Such devices would allow drip irrigation systems to operate at driving pressures much lower than those required by current available technology, allowing for cost and water savings in developing nations. Fabrication methods explored consist mainly of molding of liquid silicone rubber and production from existing silicone stock by folding or binding multiple sheets of material together. Based on small-scale production and testing, the sheet fabrication method showed some promise of equaling the performance of the injection-molded tubes, but both methods require further refinement going forward.
Description
Thesis: S.B., Massachusetts Institute of Technology, Department of Mechanical Engineering, 2014.
Cataloged from PDF version of thesis.
Includes bibliographical references (page 21).
Subjects
Mechanical Engineering.
MIT Department
Massachusetts Institute of Technology. Department of Mechanical Engineering
Terms of Use
M.I.T. theses are protected by copyright. They may be viewed from this source for any purpose, but reproduction or distribution in any format is prohibited without written permission. See provided URL for inquiries about permission.
Persistent DSpace Link