Forced-convection, dispersed-flow film boiling
Name
HTL_TR_1969_063.pdf
Size
3.98 MB
Format
Adobe PDF
Checksum (MD5)
25386971680c762b74dbbb053cbf25f3
Author(s)
Hynek, Scott Josef
Rohsenow, Warren M.
Bergles A. E.
Date Issued
1969
Publisher
Cambridge, Mass. : M.I.T. Dept. of Mechanical Engineering, [1969]
Series/Report no.
Technical report (Massachusetts Institute of Technology, Heat Transfer Laboratory) ; no. 63.
Abstract
This report presents the latest results of an investigation of the characteristics of dispersed flow film boiling. Heat transfer data are presented for vertical upflow of nitrogen in an electrically heated tube, 0.4 in. I.D. and 8 ft long. Heat fluxes up to 18,000 Btu/ft 2-hr and mass fluxes up to 200,000 lbm/ft 2-hr were investigated. By variation of the startup procedure, it was possible to operate in two distinct regimes of film boiling. By preheating the tube before introducing the flow, film boiling was observed throughout the test tube. If the flow was established before applying power, film boiling was initiated downstream of the inlet. For similar conditions, the local heat transfer coefficients were different in the two cases due to the different degrees of thermal nonequilibrium. The data for both regimes were satisfactorily predicted by a modified version of the nonequilibrium model presented in earlier reports. The model was also applied to available data for methane, propane, and water. By modification of the empirical constant governing the direct wall-to-droplet heat transfer, these data were generally predicted to within 10 percent. The tests were repeated with tight-fitting, full-length twisted tapes installed in the test tube. Considerable augmentation of the heat transfer was achieved, with the heat transfer coefficient being increased by as much as a factor of 3 with the tightest tape twist. For the higher mass fluxes, it was observed that the tape promoted droplet deposition to such an extent that a continuous liquid film could be reestablished on the wall near the test section exit. The tape-generated swirl flow did not improve the "burnout" condition, primarily due to the fact that a liquid streamer forms on the twisted tape. The semiempirical model gave a reasonable prediction of the heat transfer coefficient when the effects of the swirl flow were included.
Subjects
Boiling-points.
Heat -- Transmission.
Heat -- Convection.
Nitrogen.
Tubes -- Fluid dynamics.
Persistent DSpace Link
