The effect of manufacturing tolerances and header design on heat exchanger effectiveness
Name
48889728-MIT.pdf
Description
Full printable version
Size
13.76 MB
Format
Adobe PDF
Checksum (MD5)
458934e3fc1877cf9820514439e904aa
Author(s)
Booten, Charles (Charles William), 1978-
Advisor(s)
David Gordon Wilson.
Date Issued
2001
Publisher
Massachusetts Institute of Technology
Abstract
This study seeks to analyze the effect of manufacturing defects and inlet header design on the effectiveness of heat exchangers. A commercial computational fluid dynamics code, FLUENT 5.4, was used to numerically simulate individual and pairs of passages as well as sections of an inlet header and heat-exchanger core. The one- and two passage models show that the four representative manufacturing defects do not have a large impact on overall effectiveness, even when the defects are quite large relative to the passage dimensions. The core and header sections showed that the basic header contour and the angle of the incoming flow as well as the pressure drop through the core have a significant impact on the flow distribution. Small variations in the header dimensions and the core/header aspect ratio have little effect on the effectiveness. Decreasing the angle the incoming flow turns through and increasing the pressure drop through the core both create a more even flow distribution through the heat exchanger, hence increasing its effectiveness.
Description
Thesis (S.M.)--Massachusetts Institute of Technology, Dept. of Mechanical Engineering, 2001.
Includes bibliographical references (p. 125-129).
Subjects
Mechanical Engineering.
MIT Department
Massachusetts Institute of Technology. Department of Mechanical Engineering
Terms of Use
M.I.T. theses are protected by copyright. They may be viewed from this source for any purpose, but reproduction or distribution in any format is prohibited without written permission. See provided URL for inquiries about permission.
Persistent DSpace Link
