Effects of silica nanoparticle surface treatment and average diameter on the physical and mechanical properties of poly(dimethylsiloxane)-silica nanocomposites
Name
1055659569-MIT.pdf
Description
Full printable version
Size
4.42 MB
Format
Adobe PDF
Checksum (MD5)
605f85c1230e46b707a94d51362ee557
Author(s)
Guha, Ingrid F
Advisor(s)
Krystyn J. Van Vliet.
Date Issued
2010
Publisher
Massachusetts Institute of Technology
Abstract
The purpose of this thesis was to quantify the effects of silica nanoparticle surface treatments and average silica nanoparticle diameter on various macroscopic properties of poly(dimethylsiloxane)-silica nanocomposites, specifically stiffness, wettability, and permeability to organic solvents. Poly(dimethylsiloxane)-silica nancomposites were prepared with constant amounts (4.8 wt%, 1.8 vol%) of fumed silica nanoparticles with varying surface treatments (hexamethyldisilazane and octamethylcyclotetrasiloxane) and varying particle diameter (7 and 12 nm). The Young's elastic modulus, mass increase due to dodecane absorption after 10 minutes, and advancing and receding water contact angles were measured for each nanocomposite. PDMS-silica nanocomposites containing untreated silica nanoparticles were found to have a higher Young's elastic modulus than nanocomposites containing hexamethyldisilazane-treated silica nanoparticles with the same diameter. However, nanocomposites containing identically sized silica nanoparticles with and without the octamethylcyclotetrasiloxane surface treatment had the same stiffness. The average nanocomposite stiffness increased slightly as the untreated silica nanoparticle diameter decreased from 12 nm to 7 nm. Varying the surface treatment or particle diameter of the filler did not significantly affect the level of dodecane absorption or the wettability of the nanocomposite. All nanocomposites showed approximately 20-23 wt% increase from dodecane absorption after 10 minutes of dodecane immersion. All nanocomposites exhibited average advancing contact angles around 115-120° and average receding contact angles around 85-90°. Nanocomposites were imaged using optical coherence tomography to examine particle dispersion. Potential differences in particle dispersion are discussed.
Description
Thesis: S.B., Massachusetts Institute of Technology, Department of Materials Science and Engineering, 2010.
Cataloged from PDF version of thesis.
Includes bibliographical references (pages 35-37).
Subjects
Materials Science and Engineering.
MIT Department
Massachusetts Institute of Technology. Department of Materials Science and Engineering
Terms of Use
MIT theses are protected by copyright. They may be viewed, downloaded, or printed from this source but further reproduction or distribution in any format is prohibited without written permission.
Persistent DSpace Link