Exploration of metal 3-D printing technologies for the microfabrication of freeform, finely featured, mesoscaled structures
Name
1056953447-MIT.pdf
Description
Full printable version
Size
13.19 MB
Format
Adobe PDF
Checksum (MD5)
37944c8e21206a9d00dee72d5d31d933
Author(s)
Sun, Zhumei
Advisor(s)
Luis Fernando Velásquez-García.
Alternative Title
Exploration of metal three-dimensional printing technologies for the microfabrication of freeform, finely featured, mesoscaled structures
Date Issued
2018
Publisher
Massachusetts Institute of Technology
Abstract
This thesis investigates a mainstream metal 3-D printing technique (i.e., direct metal laser sintering of stainless steel {SS} 316L) and two relatively new metal additive manufacturing methods (i.e., lost-wax casting of sterling silver using stereolithography-printed wax masters, and binder inkjet printing of SS 316L) for the fabrication, using tens-of-microns sized voxels, of freeform, finely featured, mesoscaled metal structures part of compact systems. Characterization of the 3-D printing methods includes the assessment of dimensional accuracy and in-plane minimum feature size, measurement of vacuum outgassing and porosity, and estimation of thermal and electrical properties of the printed parts. The data demonstrate that binder inkjet printing of SS 316L has associated the smallest in-plane offset, out-of-plane offset, and eccentricity of nominally symmetric features, while showing ultra-high-vacuum compatibility and intrinsic electrical and thermal properties close to those of bulk metal. Characterization of binder inkjet-printed SS 316L MEMS cantilevers shows repeatable micron-level linear actuation and a near-isotropic Young's modulus of the printed material close to the bulk value. Also, current-voltage characteristics in air of binder inkjet-printed SS 316L MEMS corona discharge ionizers with high aspect-ratio tips are presented. In addition, high-resolution microscopy of binder inkjet-printed SS 316L electrodes part of a novel, compact, multi-electrode harmonized Kingdon mass trap estimates at -15 ptm the maximum height difference between the printed part and the digital model.
Description
Thesis: S.M., Massachusetts Institute of Technology, Department of Mechanical Engineering, 2018.
Cataloged from PDF version of thesis.
Includes bibliographical references (pages 78-92).
Subjects
Mechanical Engineering.
MIT Department
Massachusetts Institute of Technology. Department of Mechanical Engineering
Terms of Use
MIT theses are protected by copyright. They may be viewed, downloaded, or printed from this source but further reproduction or distribution in any format is prohibited without written permission.
Persistent DSpace Link
