Self-installation of drip irrigation emitters for prototype emitter testing
Name
964525521-MIT.pdf
Description
Full printable version
Size
2.2 MB
Format
Adobe PDF
Checksum (MD5)
9c700488b779bdffe2b35fc2bb5e50bb
Author(s)
Johnson, Eric (Eric M.)
Advisor(s)
Amos Winter.
Date Issued
2016
Publisher
Massachusetts Institute of Technology
Abstract
In this thesis, I tested methods of adhering factory-made drip emitters to the interior of short segments of piping. Different types of adhesive and pipe material combinations were tested, and I selected three combinations for further testing. Performance similar to factory-installed drip emitters was achieved at low pressure, but the necessary watertight seals repeatedly burst at higher water pressures. Alterations to the drip emitter and installation procedure are recommended to increase reliability and resilience of the installation.
Description
Thesis: S.B., Massachusetts Institute of Technology, Department of Mechanical Engineering, 2016.
Cataloged from PDF version of thesis.
Includes bibliographical references (page 31).
Subjects
Mechanical Engineering.
MIT Department
Massachusetts Institute of Technology. Department of Mechanical Engineering
Terms of Use
M.I.T. theses are protected by copyright. They may be viewed from this source for any purpose, but reproduction or distribution in any format is prohibited without written permission. See provided URL for inquiries about permission.
Persistent DSpace Link
