Enhanced flow boiling heat transfer in microchannels with structured surfaces at varied mass flow rates
Name
921147574-MIT.pdf
Description
Full printable version
Size
6.33 MB
Format
Adobe PDF
Checksum (MD5)
dbf6b0d8c7280c4b62055f4ca8427110
Author(s)
Bian, David (David Wei)
Advisor(s)
Evelyn N. Wang.
Date Issued
2015
Publisher
Massachusetts Institute of Technology
Abstract
This thesis investigates the role of mass flux on flow boiling heat transfer in microchannels with surface micropillar arrays. The motivation for this investigation was to determine the general trends of the optimal micropillar array geometry in terms of its heat transfer capabilities. The experiment was conducted with three microchannels: a flat surface microchannel, a sample called the 5-15 (height h = 25 [mu]m, diameter d = 5 [mu]m, and pitch l = 15 [mu]m) and a sample called the 10-40 (height h = 25 [mu]m, diameter d = 10 [mu]m, and pitch l = 40 [mu]m). The structured surface microchannels, due to their capillary pressure-induced wicking capabilities, exhibited less temperature rise and pressure drop fluctuations at high heat fluxes. Furthermore, it was verified that the critical heat flux value of all microchannels increased with mass flux. In addition, it was concluded that at lower mass fluxes, the relative percentage heat transfer enhancement of the structured surface microchannels over the flat surface microchannel was greater. The trend observed suggests that denser samples are better at lower mass fluxes. However, if a sample is too dense, there may be too much viscous drag. Thus, an optimal balance between capillary force and viscous drag must be found in order to determine the optimum micropillar array geometry and density for maximizing the critical heat flux value. Finally, for a given mass flux, the pressure drop across every microchannel was approximately equal at all heat fluxes. This implies that no additional power consumption is required to pump a particular mass flux through a structured surface microchannel than a flat surface microchannel, though there is certainly additional power required to increase the mass flux. This work provides insights into the roles of both the micropillar array surface structures and the mass fluxes on the heat transfer performance of flow boiling in microchannels. The results and observations of this experiment may prove helpful in guiding future work in an attempt to optimize microchannels for heat transfer applications in electronics.
Description
Thesis: S.B., Massachusetts Institute of Technology, Department of Mechanical Engineering, 2015.
Cataloged from PDF version of thesis.
Includes bibliographical references (pages 39-40).
Subjects
Mechanical Engineering.
MIT Department
Massachusetts Institute of Technology. Department of Mechanical Engineering
Terms of Use
M.I.T. theses are protected by copyright. They may be viewed from this source for any purpose, but reproduction or distribution in any format is prohibited without written permission. See provided URL for inquiries about permission.
Persistent DSpace Link
