Closed loop performance of polypyrrole linear contractile actuators
Name
Hunter_Closed loop.pdf
Size
1.91 MB
Format
Adobe PDF
Checksum (MD5)
4f9a429df6864c0cb017f2f172e96807
Author(s) • • •
Paster, Eli Travis
Ruddy, Bryan P.
Pillai, Priam V.
Hunter, Ian
Date Issued
May 2010
Journal
IEEE International Conference on Robotics and Automation (ICRA), 2010
Publisher
Institute of Electrical and Electronics Engineers (IEEE)
Citation
Paster, Eli, Bryan P Ruddy, Priam V Pillai, and Ian W Hunter. Closed Loop Performance of Polypyrrole Linear Contractile Actuators. In Pp. 506–511. IEEE, 2010. © Copyright 2010 IEEE
Version
Final published version
Abstract
Conducting polymer actuators such as polypyrrole can generate stresses over 10 times larger than skeletal muscle and have typical repeatable strains between 1% and 12%, making them potential candidates for lightweight, low-cost, robotic applications. Polypyrrole linear actuators under closed loop control have not been previously reported. Here we report the open and closed loop performance of polypyrrole linear contractile actuators evaluated at pre-loaded stresses of 1 MPa to 3 MPa. A standard PI control scheme driving a potentiostat was implemented in conjunction with positioning feedback from a DC/DC linear variable differential transformer (LVDT). A dynamic positioning range of 3400 is reported, with a positioning resolution of 125 nm (0.001% strain) and a maximum repeatable displacement of 427 microns (3.6% strain). The open loop frequency response of actuator strain shows characteristics of a first-order low pass filter with a log gain versus log frequency slope near -1 for frequencies tested between 0.05 Hz to 2 Hz. The closed loop frequency response of actuator strain when tracking a sinusoidal set-point signal of 0.5% strain shows characteristics of a first order system with one zero, with a corner frequency near 0.08 Hz and an operating bandwidth up to 1 Hz. Step responses at various controller output maximum voltages show a reduction in contractile response times by a factor of four, where higher voltages yield faster contractile responses.
MIT Department
Massachusetts Institute of Technology. Department of Mechanical Engineering
Terms of Use
Article is made available in accordance with the publisher's policy and may be subject to US copyright law. Please refer to the publisher's site for terms of use.
Persistent DSpace Link
DOI of Published Version
https://doi.org/10.1109/ROBOT.2010.5509724