Six-Axis Levitated Stage with a Novel Flux-Steering Magnetic Hub Actuator
Name
anthis-aanthis-ms-meche-2021-thesis.pdf
Description
Thesis PDF
Size
79.4 MB
Format
Adobe PDF
Checksum (MD5)
522a296157e313d820235ad6ba9d4e21
Author(s)
Anthis III, Austin Forrest
Advisor(s)
Trumper, David L.
Date Issued
September 2021
Publisher
Massachusetts Institute of Technology
Abstract
This thesis presents a two-axis, permanent-magnet-biased, flux-steering actuator and its integration into a levitated stage. The hub actuator consists of a steel stator ring (165 mm OD) and a steel mover cylinder (52 mm OD). The stator has four teeth evenly spaced and pointing radially inward, each with a coil of 454 turns of AWG 20 copper wire. The teeth each have a nominal air gap of 0.5 mm with the mover, though only half of the air gap is used for motion (250 µm radius circle of travel). To increase the force density, permanent magnets are arranged to create north poles on the mover and south poles on each stator tooth to introduce a bias flux in the air gap. The coils then modulate the flux in each air gap and this difference produces a force on the mover. The hub actuator produces 200 N of force in both the X and Y directions using less than 10 W of power. In addition to the 0.5 mm stroke in the horizontal plane, we required relatively large strokes in Z and θz – 3 mm and 6∘ respectively – and designed the hub to produce approximately constant force through the range.
The six-degree-of-freedom (6 DoF) experimental stage consists of six Lorentz actuators acting on an aluminum disc stage in addition to the hub actuator. Six individual single-input, single-output (SISO) controllers stabilize and control each of the six degrees of freedom. Each coil is powered by a custom, linear, transconductance amplifier with 5 kHz bandwidth. Using the stage, we demonstrated control loop bandwidths of greater than 100 Hz for the hub degrees of freedom and RMS position noise below 0.4 µm in translation and 7 µrad in rotation. During levitated operation, we produced up to 90 N of steady state force with less than 2 W of power as well as 2.8 m/s2 acceleration in a sinusoidal position trajectory with under 2 W power dissipation. The stage was designed as an efficient fine-motion stage for photolithography or other precision positioning applications.
MIT Department
Massachusetts Institute of Technology. Department of Mechanical Engineering
Terms of Use
In Copyright - Educational Use Permitted
Copyright MIT
Persistent DSpace Link
