Design of Plate-Fin Tube Dehumidifiers for Humidification-Dehumidification Desalination Systems
Name
SieversM_LienhardJHV_Design of Plate-Fin Tube Dehumidifiers for Humidifi .pdf
Size
1.71 MB
Format
Adobe PDF
Checksum (MD5)
74824008ff08f5100cea50d4a69e22b1
Author(s)
Sievers, Martin
Lienhard, John H.
Date Issued
April 2014
Journal
Heat Transfer Engineering
Publisher
Taylor & Francis
Citation
Sievers, Martin, and John H. Lienhard V. “Design of Plate-Fin Tube Dehumidifiers for Humidification-Dehumidification Desalination Systems.” Heat Transfer Engineering (April 23, 2014): pp. 1-76.
Version
Author's final manuscript
Abstract
A two-dimensional numerical model of a plate-fin tube heat exchanger for use as a dehumidifier in a humidification-dehumidification (HDH) desalination systems is developed, because typical heating, ventilating, and air conditioning (HVAC) dehumidifier models and plate-fin tube dehumidifier geometries are not intended for the considerably higher temperature and humidity ratio differences which drive heat and mass transfer in HDH desalination applications. The experimentally validated model is used to investigate the influence of various heat exchanger design parameters. Potential improvements on common plate-fin tube dehumidifier designs are identified by examining various methods of optimizing tube diameter, and longitudinal and transverse tube spacing to achieve maximum heat flow for a given quantity of fin material at a typical HDH operating point. Thicker fins are recommended than for HVAC geometries, as the thermal conductive resistance of HVAC fins restricts dehumidifier performance under HDH operating conditions.
MIT Department
Massachusetts Institute of Technology. Department of Mechanical Engineering
Terms of Use
Creative Commons Attribution-Noncommercial-Share Alike
Persistent DSpace Link
DOI of Published Version
https://doi.org/10.1080/01457632.2014.916153
