Show simple item record

dc.contributor.advisorChen, Gang
dc.contributor.authorLin, Emily
dc.date.accessioned2023-08-23T16:14:09Z
dc.date.available2023-08-23T16:14:09Z
dc.date.issued2023-06
dc.date.submitted2023-07-19T18:45:25.015Z
dc.identifier.urihttps://hdl.handle.net/1721.1/151860
dc.description.abstractThe increasing demand for low-cost, high energy density heat sources has motivated the development of compact and lightweight combustion-based devices. In this work, we first optimized the catalytic bed segmentation scheme to enhance fuel management in a mesoscale parallel-plate combustor. After contextualizing the driving parameters for combustion efficiency, we developed an energy-dense (≈236 MW/m³) entrainment-based catalytic micro-combustor for heating portable systems. The multichannel micro-combustor (coated with Pt/Al₂O₃ catalyst) leverages a copper-nichrome wire to enable quick and localized ohmic preheating durations (2-3 mins). Furthermore, we demonstrated low ignition temperature (108-125°C), which facilitates low energy consumption (~1948 J). In addition, an optimal fuel flow rate (3.09×10⁻⁸ m³/s) was determined via FEM simulations and experiments to enable fuel savings (high fuel conversion) while achieving high heat fluxes by analyzing the reaction kinetics and species transport behavior in the microchannels. Additional FEM studies were performed to optimize the heat transfer between the high thermal mass and combustor at the insulating mica sheet stack interface. Afterwards, through independent testing, we established the micro-combustor’s ability to maintain long-term autothermal combustion at a high saturation wall temperature (585°C), which was attained at short timescales to enable fast heating/cooling cyclability. The successful cyclic heating demonstration of large thermal mass additions (at least 41 times the micro-combustor’s mass), coupled with the combustor’s high energy density, shows promise for device-level implementation for a range of commercial, defense, and energy conversion applications. Finally, a combustor array was assembled and tested in an atmospheric water extractor (AWE) device in harsh environmental conditions, at temperatures ranging from 1.7°C to 43.3°C.
dc.publisherMassachusetts Institute of Technology
dc.rightsIn Copyright - Educational Use Permitted
dc.rightsCopyright retained by author(s)
dc.rights.urihttps://rightsstatements.org/page/InC-EDU/1.0/
dc.titleHigh energy density entrainment-based catalytic micro-combustor for portable devices in extreme environmental conditions
dc.typeThesis
dc.description.degreeS.M.
dc.contributor.departmentMassachusetts Institute of Technology. Department of Mechanical Engineering
mit.thesis.degreeMaster
thesis.degree.nameMaster of Science in Mechanical Engineering


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record