Show simple item record

dc.contributor.advisorIan W. Hunter.en_US
dc.contributor.authorDiaz, Juan Den_US
dc.contributor.otherMassachusetts Institute of Technology. Dept. of Mechanical Engineering.en_US
dc.date.accessioned2012-02-29T18:22:17Z
dc.date.available2012-02-29T18:22:17Z
dc.date.issued2011en_US
dc.identifier.urihttp://hdl.handle.net/1721.1/69506
dc.descriptionThesis (S.B.)--Massachusetts Institute of Technology, Dept. of Mechanical Engineering, June 2011.en_US
dc.description"June 2011." Cataloged from PDF version of thesis.en_US
dc.descriptionIncludes bibliographical references (p. 42-43).en_US
dc.description.abstractThe potential of using carbon nanotube coated flexible cloth as strain gauges was studied. Samples were prepared by sonicating strips of cloth inside a 1mg/ml carbon nanotube in propylene carbonate solution. A dynamic mechanical analyzer was built that applied uniaxial cyclical strains to the samples and recorded the force and strain applied. The DMA also provided a constant voltage to the samples while recording the resistance response of the strain gauges. The samples were tested using the dynamic mechanical analyzer for their response to variables such as strain and time. The samples were successfully tested at strains ranging from 1% to 50%. The conductivity of the samples was measured. We studied the effects that a carboxylate and the sulfonate functional groups of the carbon nanotubes have on the strain sensors, the effect of the sonication time, and the effect that leaving the strain sensors inside the solution for different amount of times has on the strain sensors. It was discovered that the samples dried overtime, thus decreasing the conductivity of the samples and damaging the strain sensors. An encapsulation method was developed and studied to counter the drying effect. The results showed that the encapsulation method did delay the decaying of the samples. Moreover, it was concluded that the sulfonate group had higher changes in resistance than the carboxylate group. While increased sonication time did not seem to have a measurable effect on the resistance of the sulfonate CNT samples, this was not true for the carboxylate group CNTs. The carboxylate group CNTs seemed to have a higher initial resistance with longer sonication time and a lower resistance with increasing time sitting in the solution. Overall, it was concluded that carbon nanotubes have a promising potential as macro level strain sensors for high-elongation applications but more development is yet to be done.en_US
dc.description.statementofresponsibilityby Juan D. Diaz.en_US
dc.format.extent43 p.en_US
dc.language.isoengen_US
dc.publisherMassachusetts Institute of Technologyen_US
dc.rightsM.I.T. theses are protected by copyright. They may be viewed from this source for any purpose, but reproduction or distribution in any format is prohibited without written permission. See provided URL for inquiries about permission.en_US
dc.rights.urihttp://dspace.mit.edu/handle/1721.1/7582en_US
dc.subjectMechanical Engineering.en_US
dc.titleTesting and characterization of carbon nanotubes as strain sensorsen_US
dc.typeThesisen_US
dc.description.degreeS.B.en_US
dc.contributor.departmentMassachusetts Institute of Technology. Department of Mechanical Engineering
dc.identifier.oclc775674869en_US


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record