Show simple item record

dc.contributor.advisorTomasz Wierzbicki.en_US
dc.contributor.authorMarcadet, Stephane (Stephane Jean Marie)en_US
dc.contributor.otherMassachusetts Institute of Technology. Dept. of Mechanical Engineering.en_US
dc.date.accessioned2012-04-26T18:53:54Z
dc.date.available2012-04-26T18:53:54Z
dc.date.copyright2012en_US
dc.date.issued2012en_US
dc.identifier.urihttp://hdl.handle.net/1721.1/70442
dc.descriptionThesis (S.M.)--Massachusetts Institute of Technology, Dept. of Mechanical Engineering, 2012.en_US
dc.descriptionCataloged from PDF version of thesis.en_US
dc.descriptionIncludes bibliographical references (p. 70-73).en_US
dc.description.abstractAdvanced high strength steel sheets are rapidly entering the transport industry, as their high strength to weight ratio helps improving fuel and costs efficiency. The early ductile fracture of these materials limits their formability and crash-worthiness. A phenomenological criterion to predict ductile fracture has been developed based on a law of damage accumulation weighted by the stress state. The calibration of such a model requires accurate measurements of the history of stress and strain state up to the onset of fracture. The phenomenon of localized necking occurs prior to ductile fracture in most types of loading of sheet metal. In order to measure the local state of stress and strain, a hybrid experimental and numerical method is tested. The Finite Element model can accurately predict the load displacement relation using a quadratic Hill 48 yield surface and an associated flow rule. The evolution of the local stresses and strains in the material are found to be non linear after necking. Results of such a method to calibrate the fracture criterion provide a validation of the model in a large range of loadings, including uniaxial, biaxial and shear. The effect of a reverse loading is then explored by developing an innovative experimental procedure to adapt the hybrid method for in plane compression followed by uniaxial tension of sheet metal. An Anti Buckling Device (ABD) and special grips are developed to delay buckling of the sheet. The hybrid method requires an accurate constitutive model of the material in the case of reverse loading for the Finite Element model. A modified Yoshida hardening called IH + LK + LNK combining isotropic hardening, linear and non linear kinematic hardening provides good prediction of the load displacement relation. An analysis of the history of local stresses and strains up to the onset of fracture suggests that limited damage is accumulated during the compression phase, validating the phenomenological model.en_US
dc.description.statementofresponsibilityby Stephane Marcadet.en_US
dc.format.extent78 p.en_US
dc.language.isoengen_US
dc.publisherMassachusetts Institute of Technologyen_US
dc.rightsM.I.T. theses are protected by copyright. They may be viewed from this source for any purpose, but reproduction or distribution in any format is prohibited without written permission. See provided URL for inquiries about permission.en_US
dc.rights.urihttp://dspace.mit.edu/handle/1721.1/7582en_US
dc.subjectMechanical Engineering.en_US
dc.titleEffect of non-linear loading paths on sheet metal fracture : large strain in-plane compression followed by uniaxial tensionen_US
dc.typeThesisen_US
dc.description.degreeS.M.en_US
dc.contributor.departmentMassachusetts Institute of Technology. Department of Mechanical Engineering
dc.identifier.oclc785728963en_US


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record