Browsing Department of Mechanical Engineering by Title
Now showing items 94-113 of 137
-
Real Time Estimation of Ship Motions Using Kalman Filtering Techniques
(Institute of Electrical and Electronic Engineers, 1983)The estimation of the heave, pitch, roll, sway, and yaw motions of a DD-963 destroyer is studied, using Kalman filtering techniques, for application in VTOL aircraft landing. The governing equations are obtained from ... -
Refrigerant forced-convection condensation inside horizontal tubes
(Cambridge, Mass. : M.I.T. Heat Transfer Laboratory, [1969], 1969)High vapor velocity condensation inside a tube was studied theoretically. The heat transfer coefficients were calculated by the momentum and heat transfer analogy. The Von Karman universal velocity distribution was applied ... -
Refrigerant forced-convection condensation inside horizontal tubes
(Cambridge, Mass. : M.I.T. Heat Transfer Laboratory, [1968], 1968)Condensing heat transfer rates inside a horizontal tube were investigated -for large quality changes across the tube. The proposed correlation is a modification of the work of Rohsenow, Webber and Ling [29]. The result of ... -
Refrigerant forced-convection condensation inside horizontal tubes
(Cambridge, Mass. : M.I.T. Heat Transfer Laboratory, [1970], 1970)High vapor velocity condensation inside a tube was studied theoretically. The heat transfer coefficients were calculated by the momentum and heat transfer analogy. The Von Karman universal velocity distribution was applied ... -
Regulation of Adenine Nucleotide Concentration at Endothelium-Fluid Interface by Viscous Shear Flow
(Biophysical Society, 1993)The action of adenine nucleotides on vascular endothelial cells is apparently mediated by the local flow conditions. Because nucleotides are sequentially degraded from ATP - ADP - AMP -- adenosine by ecto-enzymes at the ... -
Review of Experimental Work in Biomimetic Foils
(Institute of Electrical and Electronic Engineers, 2004-07)Significant progress has been made in understanding some of the basic mechanisms of force production and flow manipulation in oscillating foils for underwater use. Biomimetic observations, however, show that there is a ... -
Robust Control For Underwater Vehicle Systems With Time Delays
(Institute of Electrical and Electronic Engineers, 1991)Presented in this paper is a robust control scheme for controlling systems with time delays. The scheme is based on the Smith controller and the LQG/LTR (Linear Quadratic Gaussian/Loop Transfer Recovery) methodology. ... -
The role of surface conditions in nucleate boiling
(Cambridge, Mass. : Massachusetts Institute of Technology, Division of Industrial Cooperation, [1958], 1958)Nucleation from a single cavity has been stuied indicating that cavity gemtry is aportant in two ways. The mouth diameter determines the superheat nmeded to initiate boiling and its shape determines its stability one boiling ... -
Sequential Loop Closure Based Adaptive Autopilot Design for a Hypersonic Vehicle
(2016-03-09)This paper presents a sequential loop closure approach to designing a velocity and altitude tracking au- topilot for a hypersonic vehicle. The control architecture consists of two decoupled control subsystems, one for ... -
Simultaneous Measurements of Actin Filament Turnover, Filament Fraction, and Monomer Diffusion in Endothelial Cells
(Biophysical Society, 1998-09)The analogous techniques of photoactivation of fluorescence (PAF) and fluorescence recovery after photobleaching (FRAP) have been applied previously to the study of actin dynamics in living cells. Traditionally, ... -
Slug flow
(Cambridge, Mass. : Division of Sponsored Research, Massachusetts Institute of Technology, [1959], 1959)Introduction: When two phases flow concurrently in a pipe, they can distribute themselves in a number of different configurations. The gas could be uniformly dispersed throughout the liquid in the form of small bubbles. ... -
Some hydrodynamic characteristics of bubbly mixtures flowing vertically upward in tubes
(Cambridge, Mass. : M.I.T. Division of Sponsored Research, [1964], 1964)An investigation of bubbly flow has been conducted in vertical plexiglass tubes using air and water at atmospheric pressure. The bubbly flow pattern is an entrance condition or a non-fully developed flow. A spontaneous ... -
Squaring-Up Method for Relative Degree Two Plants
(2015-09-28)Abstract--- Non-square multi-input-multi-output (MIMO) plants are becoming increasingly common, as the addition of multiple sensors is becoming prevalent. However, square systems are needed sometimes as an leverage when ... -
A study of boiling water flow regimes at low pressures
(Cambridge, Mass. : M.I.T. Dept. of Mechanical Engineering, [1966], 1966)"A comprehensive experimental program to examine flow regimes at pressures below 100 psia for boiling of water in tubes was carried out. An electrical probe, which measures the resistance of the fluid between the centerline ... -
A study of system-induced instabilities in forced-convection flows with subcooled boiling
(Cambridge, Mass. : M.I.T. Dept. of Mechanical Engineering, [1965], 1965)A combined analytical and experimental program was carried out to investigate the problem of hydrodynamic stability of forcedconvection flows with boiling. The study was restricted to the flow of water in small channels ... -
Subcooled flow boiling of fluorocarbons
(Cambridge, Mass. : M.I.T. Heat Transfer Laboratory, [1971], 1971)A study was conducted of heat transfer and hydrodynamic behavior for subcooled flow boiling of Freon-113, one of a group of fluorocarbons suitable for use in cooling of high-power-density electronic components. Problems ... -
Supplementary Materials to "Adaptive Output-Feedback Control for A Class of Multi-Input-Multi-Output Plants with Applications to Very Flexible Aircraft"
(2016-03-22)A dominant presence of parametric model uncertainties motivates an adaptive approach for control of very flexible aircraft (VFA). This paper proposes an adaptive controller that includes a baseline design based on observers ... -
Supplementary Materials to "Adaptive Output-Feedback Control for Relative Degree Two Systems Based on Closed-Loop Reference Models"
(2015-09-14)Abstract--- In this paper, a new adaptive output-feedback controller for multi-input-multi-output (MIMO) linear plant models with relative degree two is developed. The adaptive controller includes a baseline design based ... -
Survey and Applications of the 1D Finite Element Method
(2021-01-20) -
Survey and evaluation of techniques to augment convective heat transfer
(Cambridge, Mass. : M.I.T. Dept. of Mechanical Engineering, [1965], 1965)This report presents a survey and evaluation of the numerous techniques which have been shown to augment convective heat transfer. These techniques are: surface promoters, including roughness and treatment; displaced ...
